Re: 10ER rebuild
Posted: Mon Dec 31, 2018 12:02 am
That may help. The torsion spring can acquire rusty projections.
Hopefully use(wear) will smooth things out.
Hopefully use(wear) will smooth things out.
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Are you implying that it doesn't come apart easily? From the underside I expected to see a snap ring, but it looks like there's just a concave washer that is seated around the hex pin.JPG wrote:That may help. The torsion spring can acquire rusty projections.
Hopefully use(wear) will smooth things out.
Thanks! That picture sure says it all.rpd wrote:I had mine apart some years ago, so the memory is vague. I think the knob on top unscrews from the bolt and it all comes apart. Here is a link. Also check out the rest of the thread. https://www.shopsmith.com/ss_forum/view ... 91#p235091
I taped off most surfaces like that, but wherever I got overspray that isn't wanted I've been scraping off with a razor.JPG wrote:Looking good!
I hope you did not paint the area of the jointer where the outfeed table slides against the infeed table when the depth of cut is adjusted..
WHEW! Good news!!!badtheba wrote:I taped off most surfaces like that, but wherever I got overspray that isn't wanted I've been scraping off with a razor.JPG wrote:Looking good!
I hope you did not paint the area of the jointer where the outfeed table slides against the infeed table when the depth of cut is adjusted..
Sent from my Moto Z3 Play using Tapatalk