Jointer Manual Disassemble Maintenance?

suntower · Post by **suntower** » Wed Jul 27, 2016 1:05 am

OK, I'll bite: How does one 'make' a spring to a precise dimension? Let alone a spring with tangs on each end?

rpd · Post by **rpd** » Wed Jul 27, 2016 9:23 am

suntower wrote:OK, I'll bite: How does one 'make' a spring to a precise dimension? Let alone a spring with tangs on each end?

suntower · Post by **suntower** » Wed Jul 27, 2016 2:40 pm

Of course there's a video for that. What -was- I thinking?

(There's probably a video "Build your own nuclear sub!")

Thanks,

--JC

JPG · Post by **JPG** » Wed Jul 27, 2016 5:30 pm

Some trial/error is usually involved.

rpd · Post by **rpd** » Sat Jun 03, 2017 12:11 pm

An old thread, but I had my jointer guard apart today so I thought I would post a picture showing the original spring, for future reference.

suntower · Post by **suntower** » Thu Jun 08, 2017 2:06 pm

Thanks. That helps!

Shopsmith Forums