phone  (937) 890-5197

Shopsmith Forums

%nbsp;

2 posts • Page 1 of 1

You can read about them here:

https://www.rockler.com/rockler-t-track ... -cam-clamp

You might also what to check out these Omni Stops:

Rockler Omni Stop for T-Track Table

https://www.rockler.com/rockler-omni-st ... rack-table

The clamps are more of a toggle then I had hoped for but I still think they will be useful for me. They are also higher then I would like but again there are work around to be had so all is good.

I built some added platforms for my Shaper Origin workstation using the same Rockler t-track that has sort of become my de-facto standard. Here are a couple of pictures showing the clamps on my platforms.

roc1.jpg
roc1.jpg (159.77 KiB) Viewed 703 times


roc2.jpg
roc2.jpg (155.42 KiB) Viewed 703 times


This second shot shows the workaround I mentioned.

Not going to be for everyone at that price point but for me it adds some more options that will be useful for my work flow.

Ed

---

{Knight of the Shopsmith} [Hero's don't wear capes, they wear dog tags]

Post a reply  Reply with quote 

Ed,

Nice to see that you finally got your Shaper Workstation. How do you like it so far?

---

📶RF Guy

Mark V 520 (Bought New '98) | 4" jointer | 6" beltsander | 12" planer | bandsaw | router table | speed reducer | univ. tool rest
Porter Cable 12" Compound Miter Saw | Rikon 8" Low Speed Bench Grinder w/CBN wheels | Jessem Clear-Cut TS™ Stock Guides
Festool (Emerald): DF 500 Q | RO 150 FEQ | OF 1400 EQ | TS 55 REQ | CT 26 E
DC3300 | Shopvac w/ClearVue CV06 Mini Cyclone | JDS AirTech 2000 | Sundstrom PAPR | Dylos DC1100 Pro particulate monitor

Post a reply  Reply with quote 

Who is online

Users browsing this forum: No registered users and 107 guests

Board indexDelete all board cookies

Welcome to Shopsmith. Please fill in this form and we'll send you more information and special offers for the Shopsmith MARK 7 and other woodworking topics.

Subscribe to our mailing list

* indicates required