Shopsmith Forums

From 1965. I'll bet if JPG goes through his miscellaneous engineering tools he has one of these somewhere.

I have either 2 or 3 of those depending on which end you count from...


.

I think someone drew the support upside down and on the wrong side of the bracket.

I used to have one similar, but it had 5 threaded ends.

It looks like it should do a good job, but I'm not sure what job that is.

I had one of those. Got it from my uncle Rube G. It worked great.
Bill V

I believe it's original design intention was to measure wind shield wiper blades of a specific brand.

I have one of those, set up, my Shopsmith with it. Worked perfectly.
FYI do not believe people that say you can not free hand cut perfect circles on a Shopsmith setup in table saw mode.

You can threads the posts with a standard die but you need a special tap to the cut the threads in the ambihelical nuts.