Today in the shop (scroll/jig saw extra blade storage)
Posted: Fri Apr 19, 2019 11:25 pm
This is a project that I cut out back in December but never got to finish, well until today.
I used my SO to do the holes and to cut out the parts but that was just because I had it, a shopsmith would do fine making the parts.
I still have to do some finish sanding and finish it but wanted to make sure it would work and I didn't do anything dumb when putting it together. Tubes are from a surplus store and I have less caps then tubes so the corks are about the best I can do at least for now.
Nice that is warm enough to get some projects done again!
Ed
I used my SO to do the holes and to cut out the parts but that was just because I had it, a shopsmith would do fine making the parts.
I still have to do some finish sanding and finish it but wanted to make sure it would work and I didn't do anything dumb when putting it together. Tubes are from a surplus store and I have less caps then tubes so the corks are about the best I can do at least for now.
Nice that is warm enough to get some projects done again!
Ed