dbarnes2 wrote:The end is broke off at the end , just part of the hole is left...I'm new here give me a min. and I'll figure out how to send you a pic..
That is a typical failure. Just drill a hole that the "pin" will fit into and a second hole that is the diameter of the shoulder of the pin so when the tension is in place it holds.
This is what it should look like:
I didn't have another drill press at the time that was handy, so I set the 10ER into drill press mode and used the old girl to heal herself. It truly was a piece of cake!
Thanks rpd for the use of your pic!