Page 1 of 2
on the cover
Posted: Sun Sep 29, 2013 8:21 pm
by peterm
You may recall that back in March 2012 I posted about a belt grinder I made, to be driven by a Shopsmith :
http://www.shopsmith.net/forums/showthread.htm?t=10157
I am pleased to note that photos from the article I subsequently wrote about it have been chosen for the cover of the Oct/Nov 2013 “Machinists Workshop” hobby magazine. The article is inside, starting on page 4 :
[ATTACH]22892[/ATTACH]
Posted: Sun Sep 29, 2013 8:28 pm
by algale
Congrats! I remember the project and you deserve the cover shot!
Posted: Sun Sep 29, 2013 9:42 pm
by charlese
ATTA Boy, Peter!
Posted: Mon Sep 30, 2013 1:14 am
by JPG
charlese wrote:ATTA Boy, Peter!
Ditto!!!!!!!!!!!!!!!!!!!
Posted: Mon Sep 30, 2013 7:44 am
by camerio
Well done Peter, very proud of an ingenious fellow Canadian like you.
I was thinking of using my former Shopsmith bandsaw table for something, but you are far ahead of me. I guess I missed that post on the forum when you were doing it.
You inspire me to continue and invent a use for it like you did.
Again, congratulations on your publishing this article, I will try to find the magazine !
Posted: Mon Sep 30, 2013 11:42 am
by terrydowning
Congratulations!!
Nicely done sir.
Posted: Mon Sep 30, 2013 12:36 pm
by curiousgeorge
Congratulations, Peter! Well done.
Posted: Mon Sep 30, 2013 1:24 pm
by nuhobby
ALL RIGHT!!! Just bought a hard-copy at lunch-hour!
Posted: Mon Sep 30, 2013 1:56 pm
by dusty
Congratulations and Job Well Done.
Now I gotta go get a copy of Machinist's Workshop Oct/Nov 2013.
Posted: Mon Sep 30, 2013 3:58 pm
by judaspre1982
==========================================