When my PP driver died, and I had dis-assembled the whole thing. It was clear that 1 of the screws holding the powerpro LCD/Display unit in place was loose. As mentioned above-it isnt held on by much and is limited in screw length by the possibility of driving it thru the back of the LCD circuit board if you use a too-long screw.
To reinforce the bad plastic screw joint-i filled it in with epoxy and drove the original screw into it. Now its snug again.
I wouldn't use the lcd/display unit for moving the headstock around-but I understand how it could happen - it is a prominent feature to get a hold of !
Are you a powerpro owner?
Moderators: HopefulSSer, admin
Re: Are you a powerpro owner?
I've seen the powerpro rip 2" thick red oak and rock maple. I'd like to see the digital readout while ripping a piece of apitong trailer decking.
Chad Nevels
- ---------------------------------------------------------------------
1963 Shopsmith Mark V "Goldie" 1-1/8 hp Serial # 379185
1980 Shopsmith Mark V 500
1994 Shopsmith Mark V 510
---------------------------------------------------------------------
1994 OKUMA LB15 II OSP7000
2017 OKUMA LB3000 EXII SPACE TURN MY OSP P300LA
Re: Are you a powerpro owner?
I have one (2 yrs) and really like it
Bob C
Bob C