End board routing
Moderators: HopefulSSer, admin
End board routing
I am building a midcentury modern chair for the living room. The plan designer used a Festool domino tool to make floating tenons. Not having that tool, I started out using my plunge router with edge guide. I don’t have a mortising jig. When it came to cutting the mortises in the ends of the seat back slats, the edge guide seemed inadequate. I have a late version of the Shopsmith overarm pin router. I decided to set it up horizontally and clamped stop blocks to define the cut. The length of the board was stopped by the fence. I cut 24 mortises very quickly. A bonus was that the dust collector attaches to the router setup and it was clean and fast. What a great setup!
- JPG
- Platinum Member
- Posts: 34642
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: End board routing
Since simultaneous use of both the rip fence and miter gauge is a No-No when using the Table saw function it is often overlooked as a possible setup when drilling or routing(in both vertical and horizonal position) and with the OPR as well in both positions. After all those are TS attachments!
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange