Finish for woodworking jigs & fixtures?
Moderators: HopefulSSer, admin
- BuckeyeDennis
- Platinum Member
- Posts: 3696
- Joined: Tue Jul 24, 2012 10:03 pm
- Location: Central Ohio
Re: Finish for woodworking jigs & fixtures?
Many thanks, everyone. It looks like Watco danish oil is the most popular, with wipe-on poly and spray shellac tied for second. I have some of each on hand, so I think I’ll try them all out on some BB plywood scraps and see which I like best. I’m hoping to toughen up the surface a bit, and also make it cleanable.
Re: Finish for woodworking jigs & fixtures?
normally seal it with shellac or stain and then a few coats of paste wax
Hobbyman2 Favorite Quote: "If a man does his best, what else is there?"
- General George S. Patton (1885-1945)
- General George S. Patton (1885-1945)