phone  (937) 890-5197

Shopsmith Forums

%nbsp;

12 posts 1 2

Re: Finish for woodworking jigs & fixtures?

#261195 by BuckeyeDennis » Wed Jul 17, 2019 9:49 pm

Many thanks, everyone. It looks like Watco danish oil is the most popular, with wipe-on poly and spray shellac tied for second. I have some of each on hand, so I think I’ll try them all out on some BB plywood scraps and see which I like best. I’m hoping to toughen up the surface a bit, and also make it cleanable.

Post a reply  Reply with quote 

Re: Finish for woodworking jigs & fixtures?

#261196 by Hobbyman2 » Thu Jul 18, 2019 1:17 am

normally seal it with shellac or stain and then a few coats of paste wax

---

Hobbyman2 Favorite Quote: "If a man does his best, what else is there?"
- General George S. Patton (1885-1945)

Post a reply  Reply with quote 

Who is online

Users browsing this forum: No registered users and 33 guests

Board indexDelete all board cookies

Welcome to Shopsmith. Please fill in this form and we'll send you more information about the Shopsmith MARK 7 and other woodworking topics.

Subscribe to our mailing list

* indicates required