Lathe steadyrest 2nd attempt
Moderators: HopefulSSer, admin
Lathe steadyrest 2nd attempt
Some time back I decided I needed a steady rest to stabilize some spoon handles I was turning. The design was ok but didn't preform very well and was awkward to use. (first picture) For my next attempt I went with a more traditional design. It doesn't work very well with the universal tool rest base. (see Picture 2 & 3) So if anyone has any good ideas I could sure use a new approach. I was thinking about making the base of the steady rest startle the universal base from side to side as apposed to the front to back approach I am using.
Glenn
I create problem solving challenges and opportunities for design modification, not mistakes.
SS 520 born 04/16/03, Power Station mounted Band saw , Scroll saw, Jointer, Belt sander, Overarm router, dedicated Mark V drill press, SS Maxi-clamp system, Shopsmith woodworking bench
I create problem solving challenges and opportunities for design modification, not mistakes.
SS 520 born 04/16/03, Power Station mounted Band saw , Scroll saw, Jointer, Belt sander, Overarm router, dedicated Mark V drill press, SS Maxi-clamp system, Shopsmith woodworking bench
- JPG
- Platinum Member
- Posts: 34642
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Lathe steadyrest 2nd attempt
I think the first approach would work better with smaller od bearings that are more towards the back so as to support rearward pressure. (especially with small od spoon handles).
#2 is very nicely done, but would tend to get in the way.
#2 is very nicely done, but would tend to get in the way.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange