dbarnes2 wrote:The end is broke off at the end , just part of the hole is left...I'm new here give me a min. and I'll figure out how to send you a pic..
That is a typical failure. Just drill a hole that the "pin" will fit into and a second hole that is the diameter of the shoulder of the pin so when the tension is in place it holds.
This is what it should look like:
I didn't have another drill press at the time that was handy, so I set the 10ER into drill press mode and used the old girl to heal herself. It truly was a piece of cake!
Thanks rpd for the use of your pic!
1965 Mark VII S/N 407684
1951 10 ER S/N ER 44570 -- Reborn 9/16/14
1950 10 ER S/N ER 33479 Reborn July 2016
1950 10 ER S/N ER 39671
1951 !0 ER #3 in rebuild
500, Jointer, Bsaw, Bsander, Planer
2014 Mark 7 W/Lift assist - 14 4" Jointer - DC3300
And a plethora of small stuff .....
"The trouble with quotes on the Internet is that you can never know if they are genuine." - Benjamin Franklin