Shopsmith Forums

Well, I finished the modification and install of the Kreg bandsaw fence system that was the generic version, not the SS version. I bought the generic version on sale, and I hoped that I could modify it to fit the SS bandsaw table. It turns out that there are significant differences between the two v...

Dusty, I have completed my OFT and am quite happy with it! Should have done this a long time ago. Pics attached. Thanks much Dusty for all your help. You took most of the guess work out of the process for me. Jack Jack, if you have any plans, dimensions, parts list, etc. that you are willing to sha...

George, I just took the dimensions from your post to my Kreg front rail, and it appears that the SS/Kreg front rail (that you measured in your most recent post) version differs from the standard (not specifically for SS) Kreg version (that I have). The Kreg front rail that I have is 26" long. C...

George, your last dimensions are just what I needed. Many thanks for your help on this. Hank

George, many thanks for your post. You prepared that drawing at my request, as I remember. Milling those two fence pieces would have been really expensive, and I ended up buying the rails from SS. Now I am trying to figure out where the holes go on the Kreg front rail (that attaches to the SS front ...

Jack, could you please explain what hardware you used at the outboard end of the support tube? Thanks, Hank

I have cobbled together the various parts to the Kreg upgraded bandsaw fence, but I did not buy the SS version of the fence. I would appreciate it if someone could provide me the measurements for the holes in the Kreg front fence rail (that attaches to the SS front rail). The holes in the Kreg front...

I have cobbled together the various parts to the Kreg upgraded bandsaw fence, but I did not buy the SS version of the fence. I would appreciate it if someone could provide me the measurements for the holes in the Kreg front fence rail (that attaches to the SS front rail). The holes in the Kreg front...

Everyone, thanks for your replies. I have been AWOL because of a kitchen remodel and floor sanding. I will get back to my jointer/DC3300 issue eventually! Hank

I have a new jointer with a 4" dust port. If I were to connect a 4" hose from the jointer to the 2 1/2" hose of the DC-3300, what would likely happen? Thanks, Hank