Shopsmith Forums

In search of a handle clutch MARK VII if anyone has one or can point me I. The right direction! Thank you!!

Well I broke it trying to get the outer shell of the bearing out anyway to repair?

Yes motor runs and I figured the cam goes on certain way I took a picture of it before I removed it! I can try and get the inner bearing removed tomorrow will see

Right as I was taking it off it was still in place But hanging on by a thread!You think I can replace the with Mark 5/V speed controller?

I believe what I’m going to try and do is get the Mark V control sheave machine it down first. If this doesn’t work I’ll look in to the headstock! Thank you guys

Half tempted to just go buy mark V

I’ve had to replace it since it was melted, the new cam should be here on Thur

Yes the u shaped piece has separate bearing are no longer there at all. I left the piece at work I can take a pic tomorrow and show you

The piece I circle popped off which I believe
Was held in by some bearings nothing is cracked or broken .