After a horrible 7 months I am back. WHEW!
Today I picked up a new Wood River Slap Switch. It is a 15 amp switch. If you recall I am a wheelchair dude and had some issues getting to the on/off switch. By moving the switch I don’t need to reach under anything to turn my machine off. Will a 15amp switch hold up on a Mark 5?
Next question is.... I also picked up a new Ricon grinder at Woodcraft. It’s the low speed 1/2hp grinder. I was seriously looking at the Wolverine lathe tool sharpening set up. Any of you folks like to give me some intel before I move forward? Thank You!
Portland, Oregon ( what’s left of it.)