In the photos section on the Yahoo Shopsmith10ERusers group there are two albums of photos of Chris Gentlle's Double Tilt 10ER
Double Tilt Base
cdgentile , Jul 6, 2012
I just posted some photos of a double tilt setup I have been working on. It has worked out really well and takes about 30 seconds to switch from tilting one way to another. I first drilled a 3/8 in hole completely through each tilt base and way tubes. I then made two cuts on each side of the tilt base bore one horizontal and the other vertical. After some clean up using the disc sander I inserted a 3/8in bolt and secured the bolt with a winged nut. All the work was done on another ER.
The cutting was done with an Avanti 7in circular cut-off blade (less than $3) at HD.
To tilt the unit I simply remove the two bolts on the opposite side and lift normally. This design does away with the hassle of having to remove the pins.
Chris in NC
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,