phone  (937) 890-5197

Shopsmith Forums

%nbsp;

4 posts • Page 1 of 1

Pin Router Table Part Needed

#256952 by CraigM » Wed Feb 13, 2019 1:17 pm

I'm looking for the plexiglass front guard that goes on the stand-alone pin router table system...part number 515161. I checked with ShopSmith today and they no longer stock this part. Does anyone have this guard who would be willing to sell it? Thanks in advance.

Post a reply  Reply with quote 

Re: Pin Router Table Part Needed

#256954 by reible » Wed Feb 13, 2019 3:33 pm

I don't have one of these but maybe it might work:

https://www.shopsmith.com/ownersite/cat ... shield.htm

You would not use most of it, just the plastic shield bit so a lot of cost for just that. So perhaps someone here owns both and could check it out for you. Or if you have lots of extra money you could just buy one and see.

Ed

---

{Knight of the Shopsmith} [Hero's don't wear capes, they wear dog tags]

Post a reply  Reply with quote 

Re: Pin Router Table Part Needed

#256957 by CraigM » Wed Feb 13, 2019 4:21 pm

Good idea...the shield in your link looks very similar to the one I need. However, given the cost of buying a router chuck I couldn't use with that package and since the shield may not fit my pin router setup, I'll hold out hope that someone on the forum has what I'm looking for. Thanks for the suggestion.

Post a reply  Reply with quote 

Re: Pin Router Table Part Needed

#256959 by jsburger » Wed Feb 13, 2019 4:42 pm

CraigM wrote:Good idea...the shield in your link looks very similar to the one I need. However, given the cost of buying a router chuck I couldn't use with that package and since the shield may not fit my pin router setup, I'll hold out hope that someone on the forum has what I'm looking for. Thanks for the suggestion.


I am not sure that shield will work. Certainly not out of the box but it may be able to be modified to work. The pictures show what the correct shield looks like.

Attachments

Shield1.jpg
Shield1.jpg (92.5 KiB) Viewed 126 times
Shield2.jpg
Shield2.jpg (56.75 KiB) Viewed 126 times

---

John & Mary Burger
Eagle's Lair Woodshop
Hooper, UT

Post a reply  Reply with quote 

Who is online

Users browsing this forum: cooch366, Majestic-12 [Bot] and 23 guests

Board indexDelete all board cookies

Welcome to Shopsmith. Please fill in this form and we'll send you more information about the Shopsmith MARK 7 and other woodworking topics.

Subscribe to our mailing list

* indicates required
cron