Upper Sheaves sticking?
Moderators: HopefulSSer, admin
Upper Sheaves sticking?
My 510's upper sheaves were stuck together at low speed, so I broke it down, lubed everything and reassembled. Everything was working fine. Two weeks later, when I advance the speed, it gets hard to turn at about G speed, then I get a BANG, and it goes fine up to FAST. I re-lubed without taking it all apart again, but it didn't fix it. If I stay above G... no problems; so I suspect that the fixed and control sheave are sticking together at low speed. Any suggestions?
-
JPG
- Platinum Member
- Posts: 34655
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Upper Sheaves sticking?
Did you by any chance also to all that to the 'lower' floating sheave?
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange