Page 20 of 52
Re: YouTube Videos featuring Shopsmiths
Posted: Sun Sep 09, 2018 12:01 pm
by rpd
JPG wrote:A view of the two piece quill shaft.
I am inclined to agree.
However not all(AIUI) two bearing quill shafts are two piece.
One thing not brought out in discussions is the effect slightly misaligned bearing bores in the two bearing quill has on the drive sleeve(that plastic do-hickey). Single bearing play actually provides 'automatic' alignment end to end. The plastic do-hicky functions similar to a second bearing.
I think a flexible joint behind the inner bearing would be better, but likely more $$$ if even possible.
True, the two bearing quill with two piece shaft. I'm not too concerned about my 10er two bearing quills.
Re: YouTube Videos featuring Shopsmiths
Posted: Wed Nov 21, 2018 9:00 am
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Wed May 15, 2019 1:57 pm
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Wed May 15, 2019 2:27 pm
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Wed May 15, 2019 2:36 pm
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Wed May 15, 2019 7:31 pm
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Thu May 16, 2019 12:34 am
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Thu May 16, 2019 9:24 am
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Sun May 19, 2019 1:44 am
by rpd
Re: YouTube Videos featuring Shopsmiths
Posted: Sat Jun 08, 2019 9:03 am
by rpd
An interesting lathe tool, made from a wrench.
[youtube]
https://www.youtube.com/watch?v=lixbEs30lh0[/youtube]