Shopsmith Forums

Fourteen of our Club members teamed up to build a pedal powered lathe. I made the center hub and spokes for the wheel.

If he needs a round hole, along Ed's line of thinking he could use a router with a core box bit.

so far, so good. following this story

Put your sanding disk on and turn it by hand to move the belt down in the pulley to get more room to move the loop. Hope this makes sense.

use contact cement, same as gluing a bandsaw tire

First, welcome to the forum. Next the shaft has a reverse taper(flat) at about ten o'clock. Next the pulley looks to be beyond repair. I would clean up the shaft and install a new pulley. Worst case would be to get a new cutter head. Ouch

https://www.facebook.com/permalink.php? ... on_generic

Multipurpose

This afternoon I replaced my 8 year old poly tires on my Magna band saw with the rubber tires with the help of some of the comments on this post. The groves are on the wheels on these older Magna saws. I will upload a picture with this post and hopefully it will show. My grandfather purchased this ...