Shopsmith Forums

Thanks folks for the input.. i did not know about the shifting for which I thank you... hoping you all have a merry Christmas Tim

i was speaking of other companies besides shopsmith thanks

hello folks have not been on in a while tried to look this up but found nothing... has anyone found a satisfactory replacement for jointer blades. i unfortunately took a ship out of all three hitting a nail which i do not think will sharpen out... thanks for your replies in advance Tim

many thanks folks Tim

Hello again...I have the ss band saw with cast iron table. I have been trying to figure out how the miter guide could be used as a fence after reading posts on this. would someone be kind enough to post a photo of how this is done or give me some instruction. I sure appreciate it and thank you in ad...

I do not see a place to loosen the bar on the bottom..... I have a 510. it looks like he loosens a set screw on the bottom when upright but I sure do not see it. can you advise and thanks tim

Thanks much folks for your help going to try them both. Tim

goodmorning...just purchased a 510 shopsmith. the power head does not slide well on the tubes and binds towards the ends. I have waxed and clean well and has made a little difference. Could this be caused by the head locking mechanism and if so could I get directions on fixing. Thanks in advance for...

thanks a lot to you good folks for the input. I believe I will try that good advice and use hand crank. Best regards Tim

thanks for your help on the key..... this motor for driving the planer knives is apparently miy problem.... I see on the photos of this unit that there is an electric motor which attaches to right side and controls the feed. I only have a handle here and it does not look like there is any place for ...