Shopsmith Forums

Any one from the chicago area that does refinishing work i have a friend that needs an old family dresser finished you can contact here via facebook her name is Melissa Choat It has 4 drawers and a door on the one side Just needs minor repair a sand and stain thanks and just let her know i sent you ...

i del the link and posted the youtube link
the web page had no problem with me

Well i didnt have any problems with the link
here is the youtube link for the vid of it
http://www.youtube.com/watch?v=1uynmApjhWI

i just found this
refer to my last post
its about half way through the page it shows the Snowmobile as a tank

do any one know anything about milling and tuning custom parts for shopsmith 10 E and ER i know that some one said something about some one who does and cant recall im thinking about having some custom parts made... like the left pully with the shaft on it another point would it be better to put 2 s...

you mean cause of the wood floors as of right now it wont go in there i have another shop ( at another location closer to town ( his shop and my shop are about 7/8 of a mile apart) in which i will put this if he ever decides he wants to give it up my other shop has a very large house on it and the p...

well from the small amount of reasearch i have done it weighs around 1100 pounds or so i think and yes if i get it i will rename it the USS kameljoe21 aircraft carrier and give it a nice paint job to boot this is not a bad idea to redo in this type setting this would be pretty kewl great idea now al...

this is a stock photo of one just like it off of QWWM.com
i sure this one is a 5 foot table and the one im looking at is a 7 foot table and 16" cutter on it
it has number 99 on the base which this one doesnt have on it or atleast what i can see

well i might just have a line on an older 16" jointer

it may take a while to find out what he wants for it
i will post some pic when i can get some shots of it
and some better information

what it did to fix it was this i pulled the handle off cleaned it up a bit it was a little tough coming off but did ok then i took my drill with brass wire brush attachment and cleaned the shaft up doing this first will help ease the bushing off loosed up the set screw and then proceed to remove the...