Search found 740 matches
- Fri Aug 01, 2014 6:28 am
- Forum: Maintenance and Repair
- Topic: Spray adhesive
- Replies: 9
- Views: 2769
- Sat Jul 05, 2014 5:11 pm
- Forum: Woodworking Tool Review
- Topic: Tool source drill bits
- Replies: 20
- Views: 7024
That drill bit is sad. I must say I've had this same thing happen. Got a china set, full set that is, all standard sizes by the 1/16. Sharpened 2 on the drill doctor and went to work. Granted, these are supposed to be hss. Got started on the hole, a little cutting fluid on some mild steel and the dr...
- Fri Jul 04, 2014 6:41 pm
- Forum: Maintenance and Repair
- Topic: Caster stem rusted in mounting bar
- Replies: 7
- Views: 2000
How about a torch, like an oxy acetylene torch. Works almost every time for me on anything so rusted it fails to move. Heat the part it goes into and get it good and hot, then turn, wiggle etc. Not recommended for soft metals though, or if so, use a propane torch. But typically these metals don't ru...
- Thu Jul 03, 2014 5:36 am
- Forum: Community
- Topic: American Exceptionalism -Forward this to Everyone You Know
- Replies: 43
- Views: 10489
- Wed Jul 02, 2014 1:45 pm
- Forum: Community
- Topic: American Exceptionalism -Forward this to Everyone You Know
- Replies: 43
- Views: 10489
I think this american exceptionalism stuff is overrated. We are not exceptional. At least not from the outside looking in. Putin doesn't see the exceptionalism. It's like we think we are the hottest girl in school but the one dude who doesnt agree is the one with the problem. Putin is that dude..Who...
- Thu Jun 26, 2014 6:51 pm
- Forum: Community
- Topic: Dead Broke and In Debt
- Replies: 67
- Views: 8690
Its a general statement..but one Ive come to trust. It does indicate where they lean, and that tends to tell me enough. Fair? maybe not, but in a sea of candidates, I have to sort them somehow. And yes Ive liked Dems before. But don't seem to find any now. And a guy up here, last name Connolly, set ...
- Thu Jun 26, 2014 5:02 pm
- Forum: Community
- Topic: Dead Broke and In Debt
- Replies: 67
- Views: 8690
- Sun Mar 23, 2014 8:22 am
- Forum: Community
- Topic: Advice on Drilling Steel
- Replies: 12
- Views: 2356
Or, use a carbide tipped masonry bit. This will drill hardened steel. Doubt that's hardened though. A regular HSS split point bit at 135 degrees will do fine. Speed coincides with the diameter of the bit. Drill press works best. If the bit just spins it will heat up and dull. The grinding technique ...
- Sat Feb 08, 2014 9:19 am
- Forum: Maintenance and Repair
- Topic: Rust on upper tubes
- Replies: 8
- Views: 1653
- Fri Jan 17, 2014 6:23 pm
- Forum: Maintenance and Repair
- Topic: motor question..not a SS motor
- Replies: 20
- Views: 3279
The plot continues to thicken then...so I guess dual voltage means 110 and 220 motor (like the one on this machine) and a 110 only is single voltage (like my old south bend lathe motor we worked on some time back). Jpg, you could do up a write up of some of this and make some of us very happy. Like ...