Search found 2 matches
- Thu Jul 20, 2006 11:49 am
- Forum: Beginning Woodworking
- Topic: Squaring a board
- Replies: 8
- Views: 36215
Phil Collins (I DON'T SING)
Fasten the board to a piece of scrap plywood or MDF with clamps, screws or braces you made in the shop. Steady it with shims so that one long side of the ply can touch the fence. Cut off the other side as needed, then proceed as previously mentioned.
- Thu Jul 20, 2006 11:40 am
- Forum: General Woodworking
- Topic: Shopsnith Tuneup
- Replies: 8
- Views: 2845
Phil Collins (I DON'T SING)
As a retired :)machinist, I would reccomend that you check the bearings belts and bushings without any accessory attached. This will help define the problem. If all is OK add one accessory (faceplate etc.) at a time until you isolate the culprit.