Here's what you get with the Model 520 Table System Upgrade Kit

Your upgrade starts with an expanded table system that includes a larger Worktable and Extension Table with two Floating Support Tables and a pair of Telescoping Support Legs. Put tit all together and you'll have over eight feet of table width for crosscutting even the longest boards!

To this, it adds the heavy-duty, factory-aligned Shopsmith Pro Fence with four T-Slots, two on the top and one on each face ...for attaching jigs, fixtures and aids such as our:

• Rip Fence Mounted Featherboard
• T-Track Utility Light Kit,
• Flip-Up Rip Fence Stop,

...or any shop-made jig or fixture you might build that mounts to the Fence sides or top using our Sliding T-Nuts.

Here's what you get with the Pro Fence and Table System Upgrade Kit:

• Larger Table with big 17-1/2" x 22" work surface. More support for ripping 4' x 8' plywood sheets and crosscutting even the longest boards.
• Pro Fence is 24-1/2" long by 2-1/2" thick with a double T-Slot track on the top surface plus another T-Slot on each side for attaching accessories, jigs and fixtures. Two Levers lock it rigidly to the front and rear of the Main or Extension Table with a quick flip. It also includes a wider Fence Straddler.
• New Table Carriage with dual Tilt Locks at the front and rear of the Table and a widened tube stance for added stability. Quarter-turn Hand Wheel and Lock move the table up and down - then secure it where you want it.
• Direct-Reading Rip Fence Scales let you read and instantly set the width of rip cuts up to 38-1/2" wide. Includes two interchangeable stainless steel Scales that are graduated in both 1/16" and 1/32" increments.
• Two Floating Extension Tables slide on Connecting Tubes and lock any-where between the Main Table and the end Extension Table.
• Four 27" Connecting Tubes slip through the Rails and tie the System together with locking Knobs.
• Two Telescoping Legs give added support in the middle or at the ends of the Connecting Tubes. A quick twist locks their height.
• See-Through Upper Saw Guard with etched-in depth-of-cut indicators, European-Style Riving Knife and Anti-Kickback Device
• New Lower Saw Guard, updated to accommodate Shopsmith's 12" Sanding Disc. Includes 2-1/2" diameter dust collection port.

PLUS You'll also get:

• A new, Two-position Lathe Tool Rest Arm with lever-style Adjustment Screws.
• An anti-rotation Tool Rest Post.
• A new Saw Table Insert.
• New steel Miter Gauge Bar with T-Slot Washer.
• Larger Extension Table Top (does not include vertical mounting tubes.)
• A Special Sanding Disc Hub lets you use your old style steel Disc with the Lower Saw Guard.
• A new Pro Fence System 1-1/4" diameter Saw Arbor.
• All required fittings and hardware.
• Instruction Manual, fully describing alignment, maintenance, safety, tips and techniques.
• A special Alignment Set-Up Gauge

Model 520 Table System Upgrade for Pre-2002 MARK V's
Important Note: Due to the increased size of the Model 520 Table System Upgrade Kit and how various accessories connect to it, some Pre-2002 MARK V Accessories may not fit the Pro Fence upgrade. These include (but ar not limited to) all Table Inserts, Front Table Extension, Rip Fence, Mortising Hold-Downs and some Saw Arbors.