Shopping Cart

Shopping
Cart

Shopsmith -- Your Lifetime Woodworking Partner

Products

Shopsmith
Auxiliary Vise Jaws

Plans and Hardware For a Sliding Base Plus 16 Accessory Jaws

We're offering a set of drawings (plus a 74-piece hardware pack) for creating a sliding mounting base and 16 shop-made wooden jaws that you can build for your Quick-Acting Combination Vise to grasp a variety of different sized and shaped workpieces in any number of positions. See the photos for a few examples.

Sliding base lets you move & lock vise in position wherever you want it

Sliding base lets you move & lock vise in position wherever you want it

Small, straight wooden jaws feature stick-on abrasive strips for non-slip grasping of workpieces without marring

Small, straight wooden jaws feature stick-on abrasive strips for non-slip grasping of workpieces without marring

Offset jaws let you grip large workpieces up to 11-3/8" wide

Offset jaws let you grip large workpieces up to 11-3/8" wide

When attached horizontally to the vise jaws, these auxiliary jaws allow you to hold square or round workpieces of different sizes parallel to your worktable surface

When attached horizontally to the vise jaws, these auxiliary jaws allow you to hold square or round workpieces of different sizes parallel to your worktable surface

Use these open-top V-jaws to bore a row of  in-line holes down the length of a dowel... or any 90° edge of a square workpiece... while holding your stock parallel to your worktable surface

Use these open-top V-jaws to bore a row of in-line holes down the length of a dowel... or any 90° edge of a square workpiece... while holding your stock parallel to your worktable surface

Use these enclosed V-jaws to perform the same operation as shown prior... except with a firmer, non-slip grip on your workpiece... while holding your stock parallel to the worktable surface

Use these enclosed V-jaws to perform the same operation as shown prior... except with a firmer, non-slip grip on your workpiece... while holding your stock parallel to the worktable surface

Grips Dowels or Square Workpieces Verticallly

Made to grip 1/4", 5/16", 3/8", 1/2" and 3/4" dowels or square workpieces vertically.

These two jaw designs will ensure that your stock is held 90° to your table surface

These two jaw designs will ensure that your stock is held 90° to your table surface

Includes: Dimensioned Drawings for the Sliding Base and 16 Auxiliary Jaws • 74 Piece Hardware Pack and a • Driver for the Threaded Inserts.

556439 Accessory Jaw and Base Plans and Hardware ...   $49.99

Save... Order both the Combination Vise and the Accessory Jaw Plans

556438 Combination Vise with Jaw Plans and Hardware ...   $104.99
(Item may be on back-order or is made upon ordering)

Works With Older Model Combo Vises

Works With Older Model Combo Vises

If you own an older combination vise from Shopsmith (even those from as far back as the 1980's -- see photo), the holes for mounting our auxiliary vise jaws, as well as the slots for mounting to your Mark  or Mark V worktable, are located in the IDENTICAL positions.

Product Reviews

2 Reviews -- Average Customer Rating - 3.50 out of 5 -- Read all reviews

Create your own review

Order Toll-Free by Phone, if you prefer -- 1-800-543-7586.

Call before 5:00 PM Eastern Time

Copyright © 2014 Shopsmith All rights reserved.