 |
 |
 |
Stop
paying top dollar for big
blocks of turning stock! |
 |
How
the amazing
Ring Master works
Just clamp the Ring Master over the rear Way Tube of your
MARK V; mount your workpiece disc to the special Arbor;
make a few adjustments and you’re ready to go. Here’s
a bit more detail:
1. Cut and mount the workpiece –
It can be an octagonal or round disc up to 10 5/8? in
dia. by 7/8? thick (depending on planned cutting angle).
The disc mounts to the Quill of your MARK V with a special
threaded Arbor (included) through a 1/2? diameter center
hole.
2. Determine and set the proper cutting
angle This entire process can be accomplished in about
a minute or two by following our simple instructions.
3. Position the Cutting Blades –
Make final centering adjustments to the Blades and Index
Plate so each Blade engages the workpiece properly from
the front and back sides. |
The
Ring Master is a virtually goof-proof device
for quickly turning discs up to 10 5/8? in diameter,or
a series of concentric straight or angled rings that are
then stacked and glued together to form hollow vessels
with sides of consistent thickness. The device mounts
directly to your Shopsmith MARK V and, unlike conventional
bowl turning techniques, provides the unique benefit of
virtually no waste – an important consideration
when
working with costly domestic or exotic hardwoods. A secondary
benefit of this approach is that for the novice woodturner,
there’s very little that can go wrong. Since both
of the Cutter Blades are gripped firmly in the Blade Holder
at the proper angle – and since the advancement
of the Blades
into the workpiece is controlled by the turn of a crank-style
Handle – the Ring Master cuts smoothly and with
virtually no danger of snags or other problems that could
ruin your project. |
|
4.
Make the cuts – Turn the Ring Master’s
crank-style Handle clockwise about six turns (on 3/4?
stock) to advance the left Cutter into the stock –
then turn counter-clockwise to advance the right Cutter
into the opposite side of the stock until the first ring
separates.
5. Re-position Slide Plate and Cutter
Frame Move the Ring Master’s Cutter Assembly forward
a pre-determined distance to cut the next ring.
6. Repeat steps 4 and 5 above. A great
MARK V Accessory that will save you time, save you money
and save you the aggravation that often comes with making
conventional turning mistakes. |
|
556025
Ring Master
Price $377.99
Status: Quantity is low.
Product ReviewCurrently no reviews - you can be the first to review this item.
Go
back to the Lathe
Accessories Index! |
|
|
