Shopsmith Lift Assist
Enjoy Effort-Free Lifting When You Raise Your Mark 7 or Mark V into Vertical Position for Drilling, Drum Sanding, Routing, Mortising, or Shaping
Raising your MARK V to vertical can be practically effortless!
The Shopsmith Lift-Assist Reduces the Effort Required to Raise your Mark 7 or Mark V into Vertical Position to as Little as Zero
This is the accessory many Mark V and Mark 7 owners have been wanting for some time. As we get older, we're not as strong as we used to be... and those things that were once easy for us are now a bit more difficult.
Lifting the Mark 7 or Mark V from horizontal to vertical position is one of those procedures that can get a bit tougher with age. The taller you are, of course, the higher you'll want your drill press table once it's raised... and the more difficult it gets to make the move.
But now, there's a great little helper available to take the majority of this effort out of the equation entirely. No matter what your reason for needing a little Assist-ance... in about half an hour to an hour's time, your new Shopsmith Lift-Assist will be doing that lifting work for you.
Again, we're not talking about just a fraction of that effort... but 60%, 65%, 76% up to... every last drop of effort you would normally exert to raise the Mark 7 or Mark V.
Pounds of Lift Effort Required With & Without Shopsmith Lift-Assist
From Left Side of Mark V
Pounds of effort required
Pounds of effor required
Includes: Lift-Assist Arm • Gas-Charged Cylinder • Hardware and • Simple, Step-by-Step Instructions for adding it to any Mark 7 or and model Mark V.
Note: Sorry... if you own Shopsmith's steel storage cabinets, with the lift-assist only one of them will slide under the Mark 7/Mark V for storage (if the casters are removed from the steel storage cabinets, two will fit).
Destined to become the favorite accessory of many Mark 7/Mark V owners. It's easy to install. Watch the video below to see how easy!
Mark V Lift Assist
555975 Shopsmith Lift Assist for Mark V's manufactured after 1972 ... $214.69
555998 Shopsmith Lift Assist for Mark V's manufactured before 1972 ... $214.69
Mark 7 / PowerPro Lift Assist
Shopsmith now offers an upgraded Lift-Assist with a design optimized for the PowerPro headstock, which is ten pounds heavier than a conventional Mark V headstock.
This upgraded Lift-Assist also provides a quick disconnect which allows the Mark 7 to be easily tilted left for under-table operations.
Shopsmith also offers a cylinder upgrade to add these capabilities to an existing Shopsmith Lift-Assist.
556191 Shopsmith PowerPro Lift Assist for Mark 7's and Mark V's manufactured after 1972 ...
(Item may be on back-order or is made upon ordering)
556200 Shopsmith PowerPro Lift Assist for Mark V's manufactured before 1972 ... $239.39
556199 PowerPro Cylinder Upgrade for existing Lift Assists ... $47.34
Order on the Web or by Phone, if you prefer --
Call before 4:30 PM Eastern Time
Copyright © 2017 RLFShop LLC-Shopsmith All rights reserved.