phone  (937) 890-5197

STEP 2: ASSEMBLING THE HORIZONTAL BORING COMPONENTS YOU WILL NEED TO GET STARTED

To view a brief (few-seconds long) video clip of each step being performed click on this icon play video wherever you see it.

Step 1

With the machine in horizontal position, start by attaching the drill chuck to the spindle. Tighten it securely using your 5/32" Allen wrench. play video

Attach drill chuck to spindle, tightening against the flat

Tighten Set Screw Against Flat of the Spindle

Step 2

Next, in preparation for boring, position the table carriage near the headstock with the worktable installed. You can adjust its position to the ideal distance later, when you set-up for a specific task. play video

Position the Table

Position the Table

Step 3

Attach your rip fence to the worktable. You will use the fence as a backup to keep your workpiece from moving on the table surface during your horizontal boring operation(s). play video

Install Fence

Install Fence

See How Simple That Was!

Now that you've located and assembled the components you'll need for Horizontal Boring, CLICK HERE to get started by performing the most common horizontal boring operation, doweling -- where you join two (or more) narrow boards together, to create a wide board or panel.

Getting Started

Welcome to Shopsmith. Please fill in this form and we'll send you more information about the Shopsmith MARK 7 and other woodworking topics.

First Name: Last Name:
Address:
Optional Extra Address Line:

City: ST: Zip:


Email:
Re-Enter Email Address:
Phone: ( ) -

NO - I do not yet own a MARK 7 or Mark V
YES - I own a MARK 7 or Mark V

Submit